Choosing One Of The Last Files Selected; Usb Devices On The Control - HEIDENHAIN TNC 620 User Manual

3

Choosing one of the last files selected

Call the file manager: Press the PGM MGT key.
Display the last ten files selected: Press the
LAST FILES soft key
Press the arrow keys to move the cursor to the file you wish to
select:
Moves the cursor up and down within a window
Select the file: Press the OK soft key, or
Press the ENT key
The COPY FIELD soft key allows you to copy the path of
a marked file. You can reuse the copied path later (e.g.,
when calling a program with the PGM CALL key).

USB devices on the control

Use the USB port only for file transfer and backup. Before
editing or running an NC program, save it to the hard
disk of the control. This helps to avoid duplicate data
maintenance and prevents potential problems resulting
from data transfer during program run.
Backing up data from or loading onto the control is especially easy
with USB devices. The control supports the following USB block
devices:
Floppy disk drives with FAT/VFAT file system
Memory sticks with the FAT/VFAT or exFAT file system
USB sticks with NTFS file system
Hard disks with the FAT/VFAT file system
CD-ROM drives with the Joliet (ISO 9660) file system
The control automatically detects these USB devices when they are
plugged in. If the file system is not supported, the control issues an
error message as soon as the stick is plugged in.
88
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Fundamentals | File management