First steps | Setting up tools
Editing the TOOL_P.TCH pocket table
Refer to your machine manual.
The function of the pocket table depends on the machine.
In the pocket table TOOL_P.TCH (permanently saved under
TNC:\table\) you specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P.TCH, proceed as follows:
Press the TOOL TABLE soft key
The control shows the tool table.
Press the POCKET TABLE soft key
The control shows the pocket table.
Set the EDIT soft key to ON
With the upward or downward arrow keys you can
select the pocket number that you want to edit
With the rightward or leftward arrow keys you can
select the data that you want to edit
Press the END key
Further information on this topic
Operating modes of the control
Further information: "Modes of operation", Page 65
Working with the pocket table
Further information: "Pocket table for tool changer", Page 141
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
2
51