HEIDENHAIN TNC 620 User Manual page 343

MOD functions | Entering the code number
9.3 Entering the code number
Application
The control requires a code number for the following functions:
Function
Select user parameters
Configuration of Ethernet interface
Enabling of special functions during Q-
parameter programming
The control shows in the code number dialog whether CAPS LOCK is
active.
Functions provided to the machine tool builder by the
code number dialog
The two soft keys OFFSET ADJUST and UPDATE DATA are shown in
the MOD menu of the control.
The OFFSET ADJUST soft key enables automatic determination and
subsequent saving of an offset voltage required for analog axes.
Refer to your machine manual.
This function may only be used by trained personnel!
The UPDATE DATA soft key enables the machine tool builder to install
software updates on the control.
Caution: Data may be lost!
Not following the instructions when installing updates can cause a
loss of data.
Always follow the instructions when installing software
updates!
Refer to your machine manual.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Code number
123
NET123
555343
NOTICE
9
343