HEIDENHAIN TNC 620 User Manual page 495

Tables and overviews | Machine-specific user parameters
Parameter settings
DisplaySettings
Display step for the individual axes
List of all available axes
Display step for position display in mm or degrees
0.1
0.05
0.01
0.005
0.001
0.0005
0.0001
0.00005
0.00001
Display step for position display in inches
0.005
0.001
0.0005
0.0001
0.00005
0.00001
DisplaySettings
Definition of the unit of measure valid for the display
Unit of measure for display in the user interface
metric: Use the metric system
inch: Use the inch system
DisplaySettings
Format of the NC programs and cycle display
Program entry in HEIDENHAIN Klartext conversational programming language or in DIN/ISO
HEIDENHAIN: Klartext conversational programming language for entering the program in
Positioning with Manual Data Input operating mode
ISO: DIN/ISO for entering the program in Positioning with Manual Data Input operating
mode
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
12
495