Activating A Preset - HEIDENHAIN TNC 620 User Manual

5

Activating a preset

Activating a preset in the Manual operation mode
Caution: Significant property damage!
Undefined fields in the preset table behave differently from fields
defined with the value 0: Fields defined with the value 0 overwrite
the previous value when activated, whereas with undefined fields
the previous value is kept.
Before activating a preset, check whether all columns contain
values.
Operating notes:
When activating a preset from the preset table, the
control resets any active datum shift, mirroring,
rotation, or scaling factor.
On the other hand, the Tilt working plane function
(Cycle 19 or PLANE) remains active.
Select the Manual operation mode
Press the PRESET MANAGEMENT soft key
Select the preset number that you want to
activate
Or, with the GOTO key, select the preset number
that you want to activate
Confirm with the ENT key
Press the ACTIVATE PRESET soft key
Confirm activation of the preset
The control sets the display and the basic
rotation.
Exit the preset table
Activating a preset in an NC program
Use Cycle 247 or the PRESET SELECT function in order to activate
presets from the preset table during a program run.
In Cycle 247, you can specify the number of the preset to be
activated. With the PRESET SELECT function, you can specify the
number of the preset or the entry in the Doc column that you want to
activate.
Further information: User's Manual for Programming of Machining
Cycles
200
NOTICE
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Setup | Preset management