HEIDENHAIN TNC 620 User Manual page 410

10
Configuring a connection
Before connecting to the control, you need to configure a
connection.
Configure a connection as follows:
Select the Configure icon
TNCremo opens the Connection configuration
window.
Select the Management tab
Select New...
TNCremo opens the New configuration window.
Enter the connection name
Select OK
TNCremo automatically opens the Connection
tab.
Select the Type of connection
Select the Settings tab
Enter the IP address/Host name of the control
Select OK
TNCremo saves the configuration.
Setting up a connection to the control
Once you have configured a connection, you can connect your PC to
the control
Set up a connection to the control as follows:
Select the configured connection in the selection menu
Select the Set up connection icon
The connection to the control will be set up.
410
If you use the default type of connection,
a network connection (TCP/IP) is set up
over the Ethernet interface.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
HEROS functions | Setting up data interfaces