HEIDENHAIN TNC 620 User Manual page 340

9
9.1 MOD function
The MOD functions provide additional input possibilities and
displays. In addition, you can enter code numbers to enable access
to protected areas.
Selecting MOD functions
To open the MOD menu, proceed as follows:
Press the MOD key
The control opens a pop-up window displaying
the available MOD functions.
Changing the settings
Navigation in the MOD menu is possible with the mouse and the
alphabetic keyboard alike.
Use the tab key to switch from the input area in the right window
to the group and function selections in the left window
Select the desired MOD function
Switch to the input field with the tab key or ENT key
Enter the required value for the function and confirm with OK or
make a selection and confirm with Apply
If there are multiple possible settings available, then you
can show the selection box by pressing the GOTO key.
Select the desired setting with the ENT key. If you do not
wish to change the setting, close the window with the
END key.
Exiting MOD functions
To exit the MOD menu, proceed as follows:
Press the END soft key or the END key
The control closes the pop-up window.
340
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
MOD functions | MOD function