HEIDENHAIN TNC 620 User Manual page 142

4
Selecting a pocket table in Programming mode
To select the pocket table in the Programming operating mode,
proceed as follows:
Call the file manager: Press the PGM MGT key.
Press the SHOW ALL soft key
Select a file or enter a new file name
Confirm your entry with the ENT key or the
SELECT soft key
Parameter
P
T
RSV
ST
F
L
DOC
PLC
P1 ... P5
PTYP
LOCKED_ABOVE
LOCKED_BELOW
LOCKED_LEFT
LOCKED_RIGHT
142
Meaning
Pocket number of the tool in the tool magazine
Tool number
Pocket reservation for box magazines
Special tool (ST); If your special tool blocks pockets in front of
and behind its actual pocket, these additional pockets need to be
locked in column L (status L).
The tool is always returned to the same pocket in the tool
magazine
Locked pocket (L: for Locked)
Display of the comment to the tool from TOOL.T
Information on this tool pocket that is to be sent to the PLC
Function is defined by the machine tool builder. The machine tool
documentation provides further information
Tool type. Function is defined by the machine tool builder. The
machine tool documentation provides further information
Box magazine: Lock the pocket above
Box magazine: Lock the pocket below
Box magazine: Lock the pocket at left
Box magazine: Lock the pocket at right
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Tools | Tool data
Dialog
-
Tool number?
Pocket reserv.: Yes =
ENT / No = NOENT
Special tool?
Fixed pocket? Yes =
ENT / No = NO ENT
Pocket locked Yes =
ENT / No = NO ENT
-
PLC status?
Value?
Tool type for pocket
table?
Lock the pocket
above?
Lock the pocket
below?
Lock the pocket at
left?
Lock the pocket at
right?