HEIDENHAIN TNC 620 User Manual page 335

Pallets | Batch Process Manager (option 154)
Soft key Function
Move line
Select line
Cancel marking
Insert a new Pallet, Clamping, or Program before
the cursor position
Insert a new Pallet, Clamping, or Program after
the cursor position
Delete line or block
Switch active windows
Select possible entries from a pop-up window
Reset the machining status to workpiece blank
Select workpiece-oriented or tool-oriented machin-
ing
Collapse or expand necessary manual interven-
tions
Open Extended Tool Management
Interrupt machining
Operating notes:
The TOOL MANAGEMENTand INTERNAL STOP soft
keys are available only in the Program run, single
block and Program run, full sequence operating
modes.
If the pallet table contains the W STATUS column, the
RESET THE STATUS soft key is available.
If the pallet table contains the W STATUS, METHOD,
and CTID columns, the MACHINING METHOD soft key
is available.
Further information: "Tool-oriented machining",
Page 326
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
8
335