HEIDENHAIN TNC 620 User Manual page 408

10
Define behavior after receipt of ETX
(noEotAfterEtx no. 106710)
This optional parameter sets whether an EOT character (End of
Transmission) is to be transmitted after receiving an ETX character
(End of Text).
Setting Meaning
TRUE The EOT character is not transmitted.
FALSE The control transmits the EOT character.
Settings for transmission of data using TNCserver
When transmitting data with the TNCserver PC software, the
machine parameter RS232 (no. 106700) must be set to the settings
below:
Parameters
Data transfer rate in baud
Data transmission protocol
Data bits in each transferred
character
Type of parity checking
Number of stop bits
Type of handshake
File system for file operations
HEIDENHAIN data transfer software
Application
HEIDENHAIN offers the TNCremo software for connecting a
Windows PC to a HEIDENHAIN control in order to transfer data.
Prerequisites
System requirements for TNCremo:
PC operating system:
Windows 7
Windows 8
Windows 10
PC RAM: 2 GB
Free PC hard-disk space: 15 MB
An available serial interface or connection to the control's
network
408
Selection
Has to match the setting in
TNCserver
BLOCKWISE
7 bits
EVEN
1 stop bit
RTS_CTS
FE1
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
HEROS functions | Setting up data interfaces