HEIDENHAIN TNC 620 User Manual page 460

10
Changing the current user's password
In the Current User menu item, you can change the current user's
password.
Proceed as follows to change the current user's password:
Call Current User
Select the Change password tab
Enter the old password
Press the Verify old password soft key
The control checks whether you have correctly entered your old
password.
If the password is correct, the fields New password and Repeat
password are enabled.
Enter the new password
Repeat the new password
Press the Set new password soft key
The control compares the requirements defined for passwords
by the administrator to the password you entered.
Further information: "Login to user administration", Page 452
The message Password was changed successfully appears.
Defining login with token
The control also permits login with a token. This ensures secure
login without the user having to enter a password.
Refer to your machine manual.
The machine manufacturer must prepare the machine
for use with a token. For example, an appropriate reader
must be mounted on the machine.
In the Current User menu item, you can define login with a token for
the current user.
Create a token as follows:
Call Current User
Select Create token
Select the type of token with Switch type, if required
Enter the user's password
Enter PIN, if required
Hold the token close to the reader
Select Reload list
Choose a token from the list
Select Start writing
Enter PIN, if defined
The control starts the write process.
Hold the token close to the reader until the end of the write
process.
When writing is complete, the control shows a message.
Delete token allows you to delete the created token and use
password entry again.
460
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
HEROS functions | User administration