Overview - HEIDENHAIN TNC 620 User Manual

5

Overview

Refer to your machine manual.
The control must be specifically prepared by the machine
tool builder for the use of a 3-D touch probe.
The manual touch probe functions are available only with
software option 17 (Touch Probe Functions).
If you are using a HEIDENHAIN touch probe with EnDat
interface, the software option 17, Touch Probe Functions,
is automatically enabled.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
The following touch probe cycles are available in the Manual
operation mode:
Soft key Function
Calibrating the 3-D Touch
Probe
Measuring a 3-D basic rotation
by probing a plane
Measuring a basic rotation
using a line
Setting the preset on any axis
Setting a corner as preset
Setting a circle center as preset
Setting the centerline as preset
Touch probe system data
management
206
Page
215
226
223
231
232
233
236
148
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Setup | Using a 3-D touch probe (option 17)