HEIDENHAIN TNC 620 User Manual page 350

9
9.8 Setting the counter
The Counter MOD function in the Counter settings group allows
you to change the current counter reading (actual value) and the
target value (nominal value).
To define the counter, proceed as follows:
Select the Counter settings group in the MOD menu
Define the Momentary count
Define the PGM for counter
Press the APPLY soft key
Press the OK soft key
The control saves the selected settings.
The control applies the defined values to the status display.
The following soft keys are available in the Counter MOD functions:
Soft key Function
Reset count
Increase count
Lower count
You can also enter the values directly with a connected mouse.
Further information: "Defining a counter", Page 314
350
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
MOD functions | Setting the counter