6
Positioning with manual data input (MDI)
Select Positioning w/ Manual Data Input
operating mode
Program the desired available function
Press the NC Start key
The control executes the highlighted NC block.
Further information: "Positioning w/ Manual Data
Input operating mode", Page 299
Operating and programming notes:
The following functions are not available in the
Positioning w/ Manual Data Input operating mode:
FK free contour programming
Program call
Programming graphics
Program-run graphics
Using the SELECT BLOCK and CUT OUT BLOCK soft
keys etc. you can also conveniently and rapidly reuse
program sections from other NC programs.
Further information: User's Manuals for Klartext
Programming and ISO Programming
You can control and modify Q parameters with the
soft keys Q PARAMETER LIST and Q INFO.
Further information: "Checking and changing Q
parameters", Page 272
300
Testing and running | Positioning w/ Manual Data Input operating mode
PGM CALL
SEL PGM
CALL SELECTED PGM
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022