Calling A Program From The Machine Tool; Connection Between The Programming Station And Heidenhain Pc Software - HEIDENHAIN iTNC 530 Operating Instructions Manual

Calling a program from the machine tool

U Select the Programming and Editing operating mode
U Press the PGM MGT key to call the file manager
U Select the target directory to which you want to copy the program
created with the programming station
U
Select the split-screen view
U In the right-hand window, select the <c:\pgmtransfer> directory on
the programming station PC
U Select the program to be transferred, and transfer it to the machine
tool
Refer to the TNC User's Manual for more information
about copying files.
Connection between the programming station
and HEIDENHAIN PC software
To be able to set up a connection between HEIDENHAIN PC software
(e.g. TNCremo NT or CycleDesign) and the programming station, the
programming station has a special IP address, the so-called loop-back
IP. This loop-back IP is 127.0.0.1 and must be entered in the
appropriate configuration menu of the HEIDENHAIN PC software.
Then you can set up a connection with the programming station, as if
you were connected with a machine.
32