HEIDENHAIN TNC 620 User Manual page 175

Setup | Moving the machine axes
Handwheel display
1 Only with HR 550FS radio handwheel: Shows whether the
handwheel is in the docking station or whether radio operation is
active
2 Only with HR 550FS handwheel: Display of field strength, six bars
= maximum field strength
3 Only with HR 550FS radio handwheel: Charging state of battery,
six bars = maximum charging state. A bar moves from the left to
the right during recharging
4 X+50.000: Position of the selected axis
5 *: STIB (control in operation); program run has been started or
axis is in motion
6 OFFS +0.000: Offset values from M118 or from the Global
Program Settings (Option 44)
7 S1000: Current spindle speed
8 F0: Feed rate at which the selected axis is moving
9 E: Error message
If an error message appears on the control, the handwheel
display shows the message ERROR for three seconds. Then the
letter E is shown in the display as long as the error is pending on
the control.
10 WPL: 3-D-ROT function is active
Depending on the settings in the 3-D ROT menu, the following is
displayed:
VT: The function for traversing in the tool axis direction is
active
WP: Basic rotation function is active
11 RES 0,100: Active handwheel resolution. Path traversed by the
selected axis with a handwheel revolution
12 STEP ON or OFF: Incremental jog active or inactive. If the function
is active, the control additionally displays the current traversing
step
13 Soft-key row: Selection of various functions, described in the
following sections
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
1
2
3
4
6
7 7 8
11
13
5
5
10
7 9
12
175