Starting The Test Run - HEIDENHAIN TNC 620 User Manual

2

Starting the test run

Press the RESET + START soft key
The control resets the previously active tool data.
The control simulates the active NC program up
to a programmed interruption or to the program
end.
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key
The control interrupts the test run.
Press the START soft key
The control resumes the test run after an
interruption.
Further information on this topic
Performing a test run
Further information: "Test run", Page 264
Graphic functions
Further information: "Graphics (option 20)", Page 246
Adjusting the simulation speed
Further information: "Setting the speed of the Test Run mode ",
Page 253
48
First steps | Graphically testing the workpiece (option 20)
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022