HEIDENHAIN TNC 620 User Manual page 432

10
Setting up a database
Set up the database as follows:
Select the database for saving the user data
Set up a database
Press the APPLY soft key
Press the END soft key
The control opens the System reboot required window.
Press Yes to restart the system
The control restarts.
Local LDAP database
Before you can use the Local LDAP database function, the following
requirements must be met:
The user administration is active
The useradmin user has been configured
Proceed as follows to set up a Local LDAP database:
Call the user administration
Select the LDAP user database function
The control enables the dimmed area for editing the LDAP user
database.
Select the Local LDAP database function
Select the Configuration function
The control opens the Configure local LDAP database window.
Enter the name of the LDAP domain
Enter the password
Repeat the password
Press the OK soft key
The control closes the Configure local LDAP database window.
Before you can start editing the user administration, the
control prompts you to enter the password of your local
LDAP database.
Passwords must not be trivial and must be known only to
the administrators.
Further information: "Creating further users", Page 437
If the host name or domain name of the control changes,
you need to reconfigure the local LDAP databases.
432
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
HEROS functions | User administration