6-2
DAC Linearity Test Parameters
In the Test Control window you enter the parameters for the
execution of the DAC Linearity testfunction.
SOC DAC Linearity Test Control Window
P
: The analog output pin or pins to be tested.
•
IN LIST
L
: For future enhancement. Leave this field empty.
•
OG LIST
R
: The routing set to be used.
•
OUT LIST
Measurements
In this section you select the measurements/result calculations to
be performed, and enter the required parameters.
You can choose from the available units and enter the pass/fail
limits.
The M
column allows you to select the desired calculation
ETHOD
method for the DeviceLSB.
Lesson 6 – Executing the DAC Linearity Test
261