Agilent Technologies 93000 SOC Series Training Manual page 267

Mixed-signal training

Hide thumbs Also See for 93000 SOC Series:

Table of Contents

Data Selection

Datalog Waveform Selection Window

If you see the message "No Waveform" as shown in the figure

above, the file does not contain any waveforms that can be

displayed. Possible reasons are:

The loaded file is not a Datalog file.

You are not permitted to read the file. Ensure that you have read-

To use one of the available waveform display areas, activate the

corresponding checkbox S

A Datalog file can contain many waveforms. The Data selection

boxes at the left-hand side provide browsers to make the data

selection easy.

If you choose the name of a test suite from the list, then all

further selections will be restricted to that suite.

If you, for example, select a DAC Distortion suite, the Test Names

will be restricted to "captured waveform", "processed waveform",

and "FFT" data, and only defined pins will be available.

: If you choose the name of a test from the list, then all

further selections will be restricted to that test.

: If you select a certain pin, only waveforms referring to

that pin will be available.

: If you have not made a preselection via Suite Name,

Test Name, or Pin Name, you can choose from all waveforms

contained in the Datalog file.

Lesson 6 – Executing the DAC Linearity Test

#1, #2, or #3.

Show Quick Links

Table of Contents