Agilent Technologies 93000 SOC Series Training Manual page 186

Mixed-signal training

Hide thumbs Also See for 93000 SOC Series:

Table of Contents

Lesson 2 – Waveform Digitizer Setup with the Analog Setup Tool

How to Edit the Command Line

Proceed as follows:

1 Select Instruction.

2 Select Trigger reaction (if supported by module).

3 Set Initial hardware Discard.

4 Set No. Of Averages (if supported by module).

5 Select Waveform Label.

To create a new label, choose "__DEFINE_NEW_LABEL__".

Editing a Command Line

The waveform digitizer supports the following sequencer

instructions:

The sequencer executes the next instruction as soon as it finishes the

waveform capturing specified in the NOP command line.

The sequencer pauses the sequence program flow at the line just after

the waveform capturing for the HALT line is finished. Then, the

sequencer waits for the next trigger.

At the end of sequence program flow, HALT must be used to stop the

sequence program execution.

Sequencer Instructions for a WD

NOP stands for Next OPeration, that is, the next sequencer

instruction will be executed without another trigger signal.

Show Quick Links

Table of Contents