Customizing The Mixed-Signal Tool - Agilent Technologies 93000 SOC Series Training Manual

5-3
NO TE
Lesson 5 – Waveform Generation with the Mixed-Signal Tool

Customizing the Mixed-Signal Tool

How to Customize the Main Window Displays
To change the main window displays:
In the general section menu bar, click the V
1
This brings up the SelectView window.
Choose Your View
Check the waveform display areas you wish to show or hide.
2
At least one waveform display area must be enabled.
Click OK.
3
If only G W
ENERATED AVEFORM
section will disappear, and the Waveform Analysis Functions will
not be available. That means, result data cannot be uploaded (from
an analog module to the workstation) and cannot be displayed.
If only U W
PLOADED AVEFORMS
section will disappear, and the Waveform Generation Functions
will not be available. That means, waveform data can neither be
generated nor downloaded.
Waveform data that has already been generated or uploaded is not
affected by view changes. It will reappear after the corresponding
waveform display is re-enabled.
button.
IEW
is selected, the waveform result
are selected, the waveform setup
231