Agilent Technologies 93000 SOC Series Training Manual page 43

For debugging, the Analog Setup Tool can also be used to monitor
the routing (relay settings) and the parameters of the analog mod-
ules at run-time.
Monitoring the Routing and Setup Parameters with the Analog Setup Tool
Mixed-Signal Tool
The Mixed-Signal Tool is used for waveform generation and result
waveform analysis. Generated waveforms are saved in the Mixed-
Signal File.
Various ways to generate waveforms are supported:
Standard waveforms, such as sine or ramp, can be generated with
•
a waveform editor.
• More complex waveforms can be defined by using equations.
• Multi-tone waveforms can be generated with a special editor.
Arbitrary waveforms can be defined point-by-point.
•
ASCII waveforms can be imported/exported.
•
This feature allows you to use your preferred program (e.g. Matlab
or Excel) for waveform generation.
Lesson 3 – Introduction to the Software
43