Agilent Technologies 93000 SOC Series Training Manual page 217

Mixed-signal training

Hide thumbs Also See for 93000 SOC Series:

Table of Contents

Lesson 4 – Defining the Signal Routing

For details of the routing tasks, see the manual "Test Setup",

Chapter "Using the Routing Setup Tool".

For the DAC routing, you will need two routing sets. One for the

DAC Linearity test and the other for the DAC Distortion test. The

routing tasks Connect, Loop-back, Disconnect, and Flush will be

Routing set 1 is the set to be used for the DAC Linearity test with

the High Resolution Digitizer (WDB). As the analog output signal

of the DAC is only wired to the WDA, you need to set up a loop-

back via the input multiplexer of the WDA, and via a DUT board

line to an input pin of the WDB.

Loop-back Routing to the WDB

Show Quick Links

Table of Contents