Agilent Technologies 93000 SOC Series Training Manual page 489

TIA Arming Setup Section
There are two ways to provide the arming signal. They differ in the
source of the signal.
Source = EXTERNAL
•
In this mode, the TIA is armed when it detects an edge on the
external trigger input.
Slope Mode = RISING
A rising edge arms the TIA.
Slope Mode = FALLING
A falling edge arms the TIA.
Source = AUTO
•
In this mode, the TIA is armed when it detects an edge on one of
the input channels.
Slope Mode = RISING
A rising edge arms the TIA.
Slope Mode = FALLING
A falling edge arms the TIA.
Sequence Mode = START
TIA input channel 1 is used for the arming.
Sequence Mode = STOP
TIA input channel 2 is used for the arming.
Sequence Mode = STARTFIRST
TIA input channel 1 is used for the arming.
Lesson 2 – TIA Setup
489