Mixed-Signal Test Setup Procedure - Agilent Technologies 93000 SOC Series Training Manual

1-3
Step 1
Step 2

Mixed-Signal Test Setup Procedure

At this point of time you may wish to get a general view of the
steps you need to perform to set up and run a mixed-signal test,
and which software tools are used to do this.
These steps are:
General DAC Test Procedure
In this training, steps 5 to 9 will be covered in detail. The other
steps are performed with the standard setup tools, as taught in
the Agilent 93000 SOC Series User Training, Part 1 and Part 2.
These steps will only be described very shortly.
Pin Configuration
For analog pins, the mode and identifier of the analog module
have to be entered in the Pin Configuration.
The digital pins include the trigger pin which is connected to the
analog instrument and starts its operation.
Levels
The levels refer to the digital pins. The trigger pin levels and the
digital input levels must be set in accordance with the
specification of the analog module which is used.
Lesson 1 – The Training DAC
161