Agilent Technologies 93000 SOC Series Training Manual page 307

NO TE
levels by entering the AC and DC voltages. For this, select the AC/
DC from the O
UTPUT
Calculation of Attenuation and Offset Voltage
Z is the impedance (the load) at the output pin of the AWG module.
L
Z depends on the DUT and on the DUT board design. If Z
L
600 Ω for WGA, the calculation takes the output impedance of the
AWG into account.
Selecting the Sequencer Program
In the lower left-hand corner of the Hardware Settings screen you
find the box labeled S
Sequencer / Timing Generator Setup Box
You can select an existing sequencer program from the drop down
list, and edit it by clicking E
By specifying a Sub Label of the selected sequencer program (if
such a Sub Labels was defined) in the S
Lesson 2 – Setting Up the Waveform Generator
V pull-down menu.
OLTAGE
/ T G
EQUENCER IMING ENERATOR
, if desired.
DIT
UB
is below
L
.
L field, you can
ABLE
307