Agilent Technologies 93000 SOC Series Training Manual page 82

Lesson 1 – Analog Modules
Input
Single-ended input
Differential input
One single-ended input in a core and one differential input in the other core can also be made simultaneously.
The single-ended signal and differential route can be made from
the pins shown in the following table.
Possible Input Pin in Input Route of WDE
In core 1 1 input only of 4 inputs:
A+, B+, A-, or B-
In core 2 1 input only of 4 inputs:
C+, D+. C-, or D-
In core 1 1 input only of 2 inputs:
A+&A- pair or B+&B- pair
In core 2 1 input only of 2 inputs:
C+&C- pair or D+&D- pair
Each input pin belongs to one digitizer core only, and is not
shared by the other core.
In addition to the input routes, the DC routes and loop back
routes are available in the WDE.
All routing is switched by the input multiplexer.
For other components in the digitizer (input amplifier, filter, ADC,
timing generator, sequencer, waveform memory, and SYNC_DATA
pin), see the description in "High Resolution / High Speed
Digitizer" on page 79.
82
8 inputs per module.
2 single-ended inputs
simultaneously by us-
ing core1 and core 2
4 inputs per module.
2 differential inputs
simultaneously by us-
ing core 1 and core 2