Agilent Technologies 93000 SOC Series Training Manual page 187

Lesson 2 – Waveform Digitizer Setup with the Analog Setup Tool
Example:
Example of a sequencer program:
1 NOP POST Ramp_A_1 100
2 HALT POST Ramp_A_2 100
3 HALT POST Sine_B
Trigger #1
1
NOP
Acquire
Ramp_A_1
Sequencer Programming Example
Explanation:
The first trigger (#1) starts the execution of this sequencer
•
program flow.
While the sequencer program is running, the trigger is ignored.
•
HALT pauses the sequence program flow after the 2nd command
•
line. The sequencer waits for the next trigger to continue the
sequencer program.
To avoid an incorrect sequence operation, the sequencer program
•
must be terminated by a HALT instruction (at line 3).
In the example above, the first 100 captured data points would be
discarded.
For additional information (depending on the chosen module)
please refer to the Help screen.
The Waveform Label associated with the command informs the
module, where to find the data of the waveform to be generated or
where to store the captured data.
You can choose an existing label from the browser or define a new
Waveform Label.
100
Trigger #2 Trigger #3
ignored
2
HALT pause
Acquire
Ramp_A_2
3
HALT pause
Acquire
Sine_B
187