Agilent Technologies 93000 SOC Series Training Manual page 265

NO TE
Enable R S
3
EFRESH ELECTED DATA AUTOMATICALLY
the displays of the Mixed-Signal Tool as soon as new test data is
available.
Enable A
4
UTOSCALE WHILE
waveforms are completely visible on the display.
Now you can change the upload configuration parameters as
desired. For detailed information about these parameters refer to
the manual "Test Setup", Chapter "Using the Mixed-Signal Tool".
How to Upload Data
To upload data:
Click U in the Upload Configuration window (this also saves
1
PLOAD
the present configuration)
– or –
close the Upload Configuration window by clicking D
U in the waveform result section of the Mixed-Signal Tool
PLOAD
panel
– or –
click O in the waveform result section of the Mixed-Signal
VERLAY
Tool panel.
U replaces the previous data shown in the waveform result
PLOAD
section. O lets you keep the previous data and overlay up to 8
VERLAY
waveforms.
If an uploaded waveform is not displayed on the Mixed-Signal Tool
panel, you may need to change the panel view.
Keep in mind that you can archive all displayed waveforms.
Lesson 6 – Executing the DAC Linearity Test
U . This ensures that uploaded
PLOAD
to always update
and click
ONE
265