Omron CS1W-NC113 Manual page 77

Common Parameter Area
Axis Parameter Designation
Word Address and
Enable Timing
Bit Configuration
Settings
Explanation
64
Example 1
The area in the CPU Unit's DM Area beginning with word 1F40 Hex (8000) is
designated as the operating data area. The following words are allocated (varies
with the model):
NC1j3: D8000 to D8023
NC2j3: D8000 to D8039
NC4j3: D8000 to D8071
Example 2
The area in bank 2 of the CPU Unit's EM Area beginning with word 3A98 Hex
(15000) is designated as the operating data area. The following words are allo-
cated (varies with the model):
NC1j3: E2_15000 to E2_15023
NC2j3: E2_15000 to E2_15039
NC4j3: E2_15000 to E2_15071
The word address and enable timing for the axis parameter designation setting
is shown below.
Word
NC1j3 NC2j3
m+2
The bit configuration for the word address in the above table is shown below.
15
m+2 Axis designation
The following settings are available.
Word m+2: 0X00, 0X01 (X = 0 to 9, A to F)
The meanings of each of the settings are given below.
Parameter Designation (Word m+2, Bits 00 to 07)
Specify the axis parameters to use during PCU operation. The following settings
are available.
00: The PCU will operate according to the axis parameters saved in the
PCU's flash memory.
01: The PCU will operate according to the axis parameters set in the DM
Area words allocated to Special I/O Units (m+4 onwards).
Axis Designation (Word m+2, Bits 08 to 15)
If DM Area words allocated to Special I/O Units (01) are designated as the loca-
tion of axis parameters in the parameter designation setting (bits 00 to 07), use
this setting to designate the axes to be set from the DM Area.
15 14 13
0 0 0
0 0 0
m
1 F 4
m+1
0 2 0
m
3 9
m+1 A
Name
NC4j3
Axis parameter
designation
08 07
12 11
U axis
0
designation
Section
D
0
E
8
Enable timing g
At power up or restart
Parameter designation
10 09 08
Z axis Y axis X axis
designation designation designation
4-2
00