Omron CS1W-NC113 Manual page 308

Error Code Lists
Group Name
Relative
Relative
movement movement
command
position error
Relative
movement
speed error
Relative
movement
acceleration
time error
Relative
movement
deceleration
time error
Interrupt Interrupt feeding
feeding position error
Interrupt feeding
speed error
Interrupt feeding
acceleration
time error
Interrupt feeding
deceleration
time error
Origin return Origin return
error
Origin return
acceleration
time error
Origin return
deceleration
time error
Present Present position
position error
JOG JOG speed
error
JOG
acceleration
time error
JOG
deceleration
time error
298
Code Cause
7100 The position designation of the
RELATIVE MOVEMENT
command is outside the settable
range (--1,073,741,823 to
1,073,741,823 pulses).
7101 The speed designation of the
RELATIVE MOVEMENT
command is 0 or exceeds the axis
parameters' maximum speed.
7102 The acceleration time designation
of the RELATIVE MOVEMENT
command is outside the settable
range (0 to 250 ms).
7103 The deceleration time designation
of the RELATIVE MOVEMENT
command is outside the settable
range (0 to 250 ms).
7200 The position designation of
interrupt feeding is outside the
settable range (--1,073,741,823 to
1,073,741,823 pulses).
7201 The speed designation of interrupt
feeding is 0 or exceeds the axis
parameters' maximum speed.
7202 The acceleration time designation
of interrupt feeding is outside the
settable range (0 to 250 ms).
7203 The deceleration time designation
of interrupt feeding is outside the
settable range (0 to 250 ms).
7300 The speed designation of origin
return is 0 or exceeds the axis
parameters' maximum speed.
7301 The acceleration time designation
of origin return is outside the
settable range (0 to 250 s).
7302 The deceleration time designation
of origin return is outside the
settable range (0 to 250 s).
7400 The position designated with
present position preset is outside
the settable range
(--1,073,741,823 to
1,073,741,823).
7500 The JOG speed is 0 or exceeds
the axis parameters' maximum
speed.
7501 The JOG acceleration time is
outside the settable range (0 to
250 s).
7502 The JOG deceleration time is
outside the settable range (0 to
250 s).
Section
Clearing method Operation after
Execute the The current
command again START command
after correcting the will not be
position or speed executed, but
designation to a g other operating
value in the l i th axes will not be
settable range. affected.
11-5
error
p g
ill t b