Omron CS1W-NC113 Manual page 312

Error Code Lists
Group Name
Data transfer
Write transfer:
number of
words error
Write transfer:
source word
error
Write transfer:
destination
address error
Read transfer:
number of
words error
Read transfer:
source address
error
Read transfer:
destination word
error
Error counter Error counter
reset/ reset/
Origin Origin
adjustment adjustment
output output error
Override Override error
Positioning Positioning
timer timeout
Overflow
302
Code Cause
8310 The number of write words was
set to 0 or exceeded the number
of write data words.
The parameters for the origin
search high speed and the origin
search proximity speed were not
sent together.
8311 The write source word or the write
source area was outside the
settable range.
8312 The write destination address was
outside the settable range.
8320 The number of read words was
set to 0 or exceeded the number
of read data words.
8321 The read source address was
outside the settable range.
8322 The read destination word or the
read destination area was outside
the settable range.
8400 There was an attempt to output a
error counter reset/origin
adjustment output when the
output couldn't be used.
8500 The override setting was outside
the settable range (1 to 999%).
8600 The Servo Drive's positioning
completed signal did not go ON
within the axis parameters'
specified time.
8601 The movement distance is too
long (greater than 2,147,483,646
pulses, or greater than
2,147,483,520 pulses for linear
interpolation) and so operation is
not possible.
Section
Clearing method Operation after
Execute the The current
command again START command
after changing the will not be
incorrect setting. executed, but
other operating
axes will not be
affected.
Execute the The axis will be
command again decelerated to a
stop. Other
after checking that
the output can be operating axes will
used and changing not be affected.
the ladder program
if necessary.
Execute the
command again
after correcting the
data.
Execute the The designated
command again axis will be
after making decelerated to a
adjustments such stop.
as adjusting the
Other operating
positioning monitor
axes will not be
time or the servo
affected.
system's gain, or
checking the wiring
for the positioning
completed signal
and correcting if
necessary.
Execute the The designated
command again axis will be
after reducing the decelerated to a
distance to move in stop.
one operation (by
Other operating
changing the
axes will not be
position data).
affected.
11-5
error