Axis Designation - Omron CS1W-NC113 Manual

Error Code Lists
Item Name
Positioning Sequence data
sequences error
Dwell times Dwell time error
Code Cause
3000 One of the following errors occurred in
to the positioning sequence:
3099
The completion code is not in the range 0
to 6.
The initial speed number is not in the
range 00 to 99.
The acceleration time number is not in
the range 0 to 9.
The deceleration time number is not in
the range 0 to 9.
The target speed number is not in the
range 00 to 99.
The dwell time number is not in the range
00 to 19.
One of the following errors occurred in
the axis designation:
The Y, Z, or U axis was specified for a
1-axis PCU.
The Z or U axis was specified for a 2-axis
PCU.
More than one axis is specified for
interrupt feeding or speed control, or all
axis designation settings are set to 0.
(The last two digits of the code indicate
the position data number (00 to 99)
where the error occurred.)
4001 These codes indicate that a dwell time is
to outside the settable range (0 to 9.99 s).
4019
(The last two digits of the code indicate
the dwell time number (00 to 19) where
the error occurred.)
Section
Clearing Operation after
method error
Transfer the When this error
data again after occurs during
checking and data transfer, all
correcting it. data (including
the data with the
error) specified
for transfer will
be lost.
All operating
axes will be
decelerated to a
stop.
11-5
293