Using Touch Probe Cycles - HEIDENHAIN TNC 320 User Manual

13 Using Touch Probe Cycles ..... 279

13.1 General Information about Touch Probe Cycles ..... 280
Method of function ..... 280
Consideration of a basic rotation in the Manual Operation mode ..... 280
Cycles in the Manual and El. Handwheel modes ..... 280
Touch probe cycles for automatic operation ..... 281
13.2 Before You Start Working with Touch Probe Cycles ..... 283
Maximum traverse to touch point: DIST in touch probe table ..... 283
Set-up clearance to touch point: SET_UP in touch probe table ..... 283
Orient the infrared touch probe to the programmed probe direction: TRACK in touch probe table ..... 283
Touch trigger probe, probing feed rate: F in touch probe table ..... 284
Touch trigger probe, rapid traverse for positioning: FMAX ..... 284
Touch trigger probe, rapid traverse for positioning: F_PREPOS in touch probe table ..... 284
Multiple measurements ..... 284
Confidence interval of multiple measurements ..... 284
Executing touch probe cycles ..... 285
13.3 Touch Probe Table ..... 286
General information ..... 286
Editing touch probe tables ..... 286
Touch probe data ..... 287
28