Show Ip Igmp Snooping Groups - Cisco 300 Series Cli Manual

IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example displays the CPE VLAN to Multicast TV VLAN mappings.
switchxxxxxx# show ip igmp snooping cpe vlans
CPE VLAN Multicast-TV VLAN
-------- ------------------
2 1118
3 1119

21.16 show ip igmp snooping groups

To display the Multicast groups learned by the IGMP snooping, use the show ip
igmp snooping groups command in User EXEC mode.
Syntax
show ip igmp snooping groups [vlan
ip-address
[source ]
Parameters
•
vlan-id
vlan —(Optional) Specifies the VLAN ID.
•
ip-multicast-address
address
address.
•
p-address
source i
Command Mode
User EXEC mode
User Guidelines
To see all Multicast groups learned by IGMP snooping, use the show ip igmp
snooping groups command without parameters.
Use the show ip igmp snooping groups command with parameters to see a
needed subset of all Multicast groups learned by IGMP snooping
To see the full Multicast address table (including static addresses), use the
bridge multicast address-table
vlan-id
] [address
—(Optional) Specifies the IP multicast
—(Optional) Specifies the IP source address.
command.
21
ip-multicast-address
]
show
446