Table of Contents
Advertisement
36
765
36.5 lldp management-address
To specify the management address advertised by an interface, use the lldp
management-address Interface (Ethernet) Configuration mode command. To stop
advertising management address information, use the no form of this command.
Syntax
lldp management-address
no lldp management-address
Parameters
•
ip-address—Specifies the static management address to advertise.
•
none—Specifies that no address is advertised.
•
automatic—Specifies that the software automatically selects a
management address to advertise from all the IP addresses of the product.
In case of multiple IP addresses, the software selects the lowest IP address
among the dynamic IP addresses. If there are no dynamic addresses, the
software selects the lowest IP address among the static IP addresses.
•
interface-id
automatic
management address to advertise from the IP addresses that are
configured on the interface ID. In case of multiple IP addresses, the
software selects the lowest IP address among the dynamic IP addresses of
the interface. If there are no dynamic addresses, the software selects the
lowest IP address among the static IP addresses of the interface. The
interface ID can be one of the following types: Ethernet port, port-channel
or VLAN. Note that if the port or port- channel are members in a VLAN that
has an IP address, that address is not included because the address is
associated with the VLAN.
Default Configuration
No IP address is advertised.
The default advertisement is automatic.
Command Mode
Interface (Ethernet) Configuration mode
Link Layer Discovery Protocol (LLDP) Commands
{ip-address | none | automatic [interface-id]}
—Specifies that the software automatically selects a
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
