Active And Full Zone Set Configuration Guidelines - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Active and Full Zone Set Configuration Guidelines

• Hard zoning cannot be disabled.
• Name server queries are soft-zoned.
• Only active zone sets are distributed.
• Unzoned devices cannot access each other.
• A zone or zone set with the same name can exist in each VSAN.
• Each VSAN has a full database and an active database.
• Active zone sets cannot be changed, without activating a full zone database.
• Active zone sets are preserved across switch reboots.
• Changes to the full database must be explicitly saved.
• Zone reactivation (a zone set is active and you activate another zone set) does not disrupt existing traffic.
If required, you can additionally configure the following zone features:
• Propagate full zone sets to all switches on a per VSAN basis.
• Change the default policy for unzoned members.
• Interoperate with other vendors by configuring a VSAN in the interop mode. You can also configure
• Bring E ports out of isolation.
Active and Full Zone Set Configuration Guidelines
Before configuring a zone set, consider the following guidelines:
• Each VSAN can have multiple zone sets but only one zone set can be active at any given time.
• When you create a zone set, that zone set becomes a part of the full zone set.
• When you activate a zone set, a copy of the zone set from the full zone set is used to enforce zoning,
• The administrator can modify the full zone set even if a zone set with the same name is active. However,
• When the activation is done, the active zone set is automatically stored in persistent configuration. This
• All other switches in the fabric receive the active zone set so they can enforce zoning in their respective
• Hard and soft zoning are implemented using the active zone set. Modifications take effect during zone
• An FC ID or Nx port that is not part of the active zone set belongs to the default zone and the default
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
546
one VSAN in the interop mode and another VSAN in the basic mode in the same switch without disrupting
each other.
and is called the active zone set. An active zone set cannot be modified. A zone that is part of an active
zone set is called an active zone.
the modification will be enforced only upon reactivation.
enables the switch to preserve the active zone set information across switch resets.
switches.
set activation.
zone information is not distributed to other switches.
Configuring and Managing Zones
OL-16597-01