Committing The Active Package Set; Deactivating And Removing Packages - Cisco Nexus 3548 series Configuration Manual

Committing the Active Package Set

Step 4
Step 5

Committing the Active Package Set

When an SMU package is activated on the device, it becomes part of the current running configuration. To
make the package activation persistent across system-wide reloads, you must commit the package on the
device.
Procedure
Step 1
Step 2

Deactivating and Removing Packages

When a package is deactivated, it is no longer active on the device, but the package files remain on the boot
disk. The package files can be reactivated later, or they can be removed from the disk.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
194
Command or Action
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Install operation 1 completed
successfully at
Thu Jan 9 01:27:56 2014
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Install operation 2 !!WARNING!! This
patch will get
activated only after a reload of the
switch. at
Sun Mar 9 00:42:12 2014
Repeat Step 3 until all packages are activated.
(Optional) show install active
Example:
switch# show install active
Command or Action
install commit filename
Example:
switch# install commit
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
(Optional) show install committed
Example:
switch# show install committed
Performing Software Maintenance Upgrades (SMUs)
Purpose
activated. (Skip this step if the package was
activated earlier with the install add activate
command.)
Press ? after a partial package name
Note
to display all possible matches
available for activation. If there is
only one match, press the Tab key
to fill in the rest of the package
name.
Activates additional packages as required.
Displays all active packages. Use this command
to determine if the correct packages are active.
Purpose
Commits the current set of packages so that
these packages are used if the device is
restarted.
Displays which packages are committed.