Delay-Restore - Dell S4810 Reference Manual

Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.2(0.2)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
Related show vlt statistics
Commands

delay-restore

Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer
switches.
S4810
Syntax
delay-restore
Parameters
delay-restore
Defaults Not configured.
Virtual Link Trunking (VLT)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Added multicast and ndp parameters.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
— displays statistics on VLT operations.
Enter the amount of time, in seconds, to delay bringing up
the VLT ports after the VLTi device is reloaded or after the
peer-link is restored between VLT peer switches. The range
from 1 to 1200. The default is 90 seconds.
1719