Configuring Voip Lan Interface For Oamp; Web Interface - AudioCodes Mediant 4000 SBC User Manual

User's Manual
4

Configuring VoIP LAN Interface for OAMP

You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page 35

Embedded command line interface (CLI) - see ''CLI'' on page 37
Note:
page 543 for initial setup.
4.1

Web Interface

The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.

To configure the VoIP-LAN IP Address for OAMP, using the Web interface:
1. Connect the first Ethernet port group (top-left ports 1 and 2) located on the front panel
directly to the network interface of your computer, using a straight-through Ethernet
cable.
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the
default IP address of the device; the Web interface's Web Login screen appears:
Version 7.0
If you are implementing the High Availability feature, see also HA Overview on
Figure 4-1: Web Login Screen
4. Configuring VoIP LAN Interface for OAMP
35 Mediant 4000 SBC