Configuring Voip Lan Interface For Oamp; Web Interface - AudioCodes Mediant 800B User Manual

User's Manual
4

Configuring VoIP LAN Interface for OAMP

You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page 39

Embedded command line interface (CLI) - see ''CLI'' on page 41
Note:
page 711 for initial setup.
4.1

Web Interface

The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.

To configure the VoIP-LAN IP Address for OAMP, using the Web interface:
1. Connect Port 1 (left-most LAN port) located on the front panel directly to the network
interface of your computer, using a straight-through Ethernet cable.
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
3. Access the Web interface:
Version 7.0
If you are implementing the High Availability feature, see also HA Overview on
4. Configuring VoIP LAN Interface for OAMP
39 Mediant 800B Gateway and E- SBC