Configuring Voip Lan Interface For Oamp; Web Interface - AudioCodes Mediant 3000 User Manual

User's Manual
4

Configuring VoIP LAN Interface for OAMP

You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page 47

Embedded command line interface (CLI) - see ''CLI'' on page 49

Bootstrap Protocol (BootP) - see BootP/TFTP Server on page 51
Note:
3000 Simplex mode. For Mediant 3000 High Availability (HA) mode, see Assigning an
IP Address for Mediant 3000 HA on page 53.
4.1

Web Interface

The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.

To configure the VoIP-LAN IP Address for OAMP, using the Web interface:
1. Connect one of the Ethernet ports located on the RTM-8410 or RTM-6310 directly to
the network interface of your computer, using a straight-through Ethernet cable.
Figure 4-1: LAN Connection to PC for Initial Connectivity for RTM-8410
Version 7.0
This section describes how to change the default LAN IP address for Mediant
4. Configuring VoIP LAN Interface for OAMP
47 Mediant 3000