Configuring Voip Lan Interface For Oamp; Web Interface - AudioCodes Mediant 1000B User Manual

User's Manual
4

Configuring VoIP LAN Interface for OAMP

You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page 41

Embedded command line interface (CLI) - see ''CLI'' on page 43
4.1

Web Interface

The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.

To configure the VoIP-LAN IP Address for OAMP through Web interface:
1. Connect Ethernet port 0/1 or 0/2 located on the CRMX module directly to the network
interface of your computer, using a straight-through Ethernet cable.
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
Version 7.2
4. Configuring VoIP LAN Interface for OAMP
41 Mediant 1000B Gateway & E-SBC