H3C S5500-EI series Operation Manual page 1124

Operation Manual – Cluster Management
H3C S5500-EI Series Ethernet Switches
III. Configuration procedure
1) Configuring the member device (All member devices have the same configuration,
taking one member as an example)
# Enable NDP globally and for the Ethernet1/1 port.
<Switch> system-view
[Switch] ndp enable
[Switch] interface Ethernet1/1
[Switch- Ethernet1/1] ndp enable
[Switch- Ethernet1/1] quit
# Enable NTDP globally and for the Ethernet1/0/1 port.
[Switch] ntdp enable
[Switch] interface Ethernet1/1
[Switch-Ethernet1/1] ntdp enable
[Switch-Ethernet1/1] quit
# Enable the cluster function.
[Switch] cluster enable
2) Configuring the management device
# Enable NDP globally and for the GigabitEthernet1/0/2,GigabitEthernet1/0/3 ports.
<Switch> system-view
[Switch] ndp enable
[Switch] interface GigabitEthernet1/0/2
[Switch- GigabitEthernet1/0/2] ndp enable
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface GigabitEthernet1/0/3
[Switch-GigabitEthernet1/0/3] ndp enable
[Switch-GigabitEthernet1/0/3 quit
# Configure the period for the receiving device to keep NDP packets as 200 seconds.
[Switch] ndp timer aging 200
# Configure the interval to send NDP packets as 70 seconds.
[Switch] ndp timer hello 70
# Enable NTDP globally and for the GigabitEthernet1/0/2,GigabitEthernet1/0/3 ports.
[Switch] ntdp enable
[Switch] interface GigabitEthernet1/0/2
[Switch-GigabitEthernet1/0/2] ntdp enable
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface GigabitEthernet1/0/3
[Switch-GigabitEthernet1/0/3] ntdp enable
[Switch-GigabitEthernet1/0/3] quit
Chapter 1 Cluster Management Configuration
1-24