Tcp Test Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Failures due to other errors: 0

1.12.7 TCP Test Configuration Example

I. Network requirements
Use the NQA TCP function to test the time for establishing a TCP connection between
Device A and Device B. The port number used is 9000.
II. Network diagram
Figure 1-9 Network diagram for the TCP test
III. Configuration procedure
1) Configure Device B.
# Enable the NQA server and configure the listening IP address as 10.2.2.2 and port
number as 9000.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server tcp-connect 10.2.2.2 9000
2) Configure Device A.
# Create a TCP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type tcp
[DeviceA-nqa-admin-test-tcp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-tcp] destination port 9000
[DeviceA-nqa-admin-test-tcp] quit
# Enable the TCP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of one TCP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2000-04-27 14:03:20.1
Receive response times: 1
1-30
Chapter 1 NQA Configuration