H3C S5500-EI series Operation Manual page 1139

Operation Manual – SNMP-RMON
H3C S5500-EI Series Ethernet Switches
II. Configuring Trap transmission parameters
Follow these steps to configure Trap:
Enter system view
Configure target host
attribute for Traps
Configure the source
address for Traps
Extend the standard
linkUp/linkDown Traps
defined in RFC
Configure the queue size
for sending Traps
Configure the lifetime for
Traps
Note:
The extended linkUp/linkDown Traps comprise the standard linkUp/linkDown Traps
defined in RFC plus interface description and interface type. If the extended messages
are not supported on NMS, you can disable this function and enable the device to send
standard linkUp/linkDown Traps.
To do...
system-view
snmp-agent target-host
trap address
udp-domain { ip-address
| ipv6 ipv6-address }
[ udp-port port-number ]
params securityname
security-string [ v1 | v2c |
v3 [ authentication |
privacy ] ]
snmp-agent trap source
interface-type
{ interface-number |
interface-number.subnum
ber }
snmp-agent trap if-mib
link extended
snmp-agent trap
queue-size size
snmp-agent trap life
seconds
Use the command...
1-8
Chapter 1 SNMP Configuration
Remarks
—
Required
Optional
Optional
Standard linkUp/linkDown
Traps defined in RFC are
used by default.
Optional
100 by default
Optional
120 seconds by default