Configuring Synchronous Information Output; Displaying And Maintaining Information Center - H3C S5500-EI series Operation Manual

Operation Manual – Information Center
H3C S5500-EI Series Ethernet Switches

1.2.8 Configuring Synchronous Information Output

Synchronous information output refers to the feature that if the user's input is
interrupted by system output such as log, trap, or debugging information, then after the
completion of system output the system will display a command line prompt (in
command editing mode a prompt, or a [Y/N] string in interaction mode) and your input
so far.
This command is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, you can continue your operations from where
you were stopped.
Follow these steps to enable synchronous information output:
Enter system view
Enable synchronous
information output
Note:
If you do not input any information following the current command line prompt, the
system does not display any command line prompt after system information output.
In the interaction mode, you are prompted for some information input. If the input is
interrupted by system output, no system prompt will be made, rather only your input
will be displayed in a new line.

1.3 Displaying and Maintaining Information Center

Display channel
information for a
specified channel
Display the
configurations on each
output destination
Display the state of the
log buffer and the log
information recorded
Display a summary of
the log buffer
To do...
system-view
info-center
synchronous
To do...
display channel
[ channel-number |
channel-name ]
display info-center
display logbuffer [ level severity
| size buffersize ] * [ | { begin |
exclude | include } text ]
display logbuffer summary
[ level severity ]
Chapter 1 Information Center Configuration
Use the command...
Use the command...
1-14
Remarks
—
Required
Disabled by default
Remarks
Available in any view
Available in any view
Available in any view
Available in any view