Transit Node Configuration Example - H3C S5500-EI series Operation Manual

Operation Manual – RRPP
H3C S5500-EI Series Ethernet Switches
Enter system view
Create an RRPP domain
and enter its view
Specify a control VLAN for
the RRPP domain
Specify the current device
as the transit node of the
ring, and specify the
primary port and the
secondary port
Enable the RRPP ring
Return to system view
Enable RRPP
Caution:
The control VLAN configured for an RRPP domain must be a new one.
Control VLAN configuration is required for configuring an RRPP ring.
To use the undo rrpp domain command to remove an RRPP domain, you must
ensure the RRPP domain has no RRPP ring.

1.4.2 Transit Node Configuration Example

I. Network requirements
Specify the device in RRPP domain 1;
Set VLAN 4092 as the control VLAN;
Specify the device as the transit node of primary ring 1 in RRPP domain 1,
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the
secondary port.
II. Configuration procedure
<Sysname> system-view
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
ring ring-id enable
quit
rrpp enable
Use the command...
1-13
Chapter 1 RRPP Configuration
Remarks
—
Required
Required
Required
Required
By default, the RRPP ring
is disabled.
—
Required
By default, RRPP is
disabled.