Ipv6-Based Vrrp Configuration Examples - H3C S5500-EI series Operation Manual

Operation Manual – VRRP
H3C S5500-EI Series Ethernet Switches
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above information indicates that in standby group 1 Switch A is the master, Switch
B is the backup and the host with the default gateway of 202.38.160.111/24 accesses
the Internet through Switch A; in standby group 2 Switch A is the backup, Switch B is
the master and the host with the default gateway of 202.38.160.112/24 accesses the
Internet through Switch B.

1.5 IPv6-Based VRRP Configuration Examples

This section provides these configuration examples:
Single VRRP Standby Group Configuration Example
VRRP Interface Tracking Configuration Example
Multiple VRRP Standby Group Configuration Example
1.5.1 Single VRRP Standby Group Configuration Example
I. Network requirements
Host A needs to access Host B on the Internet, using FE80::10 as its default
gateway.
Switch A and Switch B belong to standby group 1 with the virtual IP address of
FE80::10.
If Switch A operates normally, packets sent from Host A to Host B are forwarded
by Switch A; if Switch A fails, packets sent from Host A to Host B are forwarded by
Switch B.
: 100
: YES
: NONE
: 202.38.160.111
: 202.38.160.1
: Vlan-interface2
: 2
: UP
: 110
: YES
: NONE
: 202.38.160.112
: 0000-5e00-0102
: 202.38.160.2
1-29
Chapter 1 VRRP Configuration
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0